edcforums

Magpul

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #13265
    admin
    Keymaster

    After Colorado passed it’s gun control messages, Magpul said they were pulling out of the state. It’s been six months, has anyone heard anything on when or where they’re moving?

    #26132
    admin
    Keymaster

    Don’t know; although its been around a long while so I’d think it was better than some of the cheap cr*p found on Amazon and the like. I personally am a fan of the Otterbox products although they can be a bit bulky…

    I’ll be watching this thread to see what others comment!

    Am Yisrael Chai!

    Moshe ben David

    #26133
    admin
    Keymaster

    I have never used a magpul phone case. My 2 go to are lifeproof and otterbox, it all depends on what is available for the phone I’m using. Never had any issue with either of them.

    #26134
    admin
    Keymaster

    Magpul iPhone cases have been my exclusive smartphone protection cases since the 4. Still using a Magpul on a 6S. Check their website if they’re still making them for current line of phones. I like the squared off edges and minimum bulk. Doesn’t flake, peel or absorbs grease from hands or environment.

    #26135
    admin
    Keymaster

    Could it fit a popsocket
    How does it compare to otter box

    Sent from my iPhone using Tapatalk

    #26136
    admin
    Keymaster

    I’ve been using magpul cases for a long time as well. In the hand, the grip is good due to the raised lines of the design and the lightly textured surface. I find though that the phone will slide around a lot on surfaces as the material is more like hard plastic than a grippy rubber, if you will. When I was overseas a while back I got a rubber textured adhesive (specifically made for the back of phones, found it easy on amazon, but forget the name) to place on the back so I could set it down on metal surfaces in mil vehicles and it wouldn’t slide all over the truck.

Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.