So I took these Kel Tec PF9, Glock 19

And this

Glock ran flawless as usuall. Ar flawless as well, it’s more accurate than I am.

Kel tec was another story. And I know, I get it not everyone is a fan of their guns. I was getting failure to feeds today. I should of snapped a pic but I was busy focusing on being safe, removing the mag, checking the chamber and keeping a busy range safe  i did not want to wind up being on the range idiot and jerk thread ~ Anyway back on track to failure to feeds. It seemed on the first failure that it was a little jammed up and bullet was just low of the guide. The later fails were more on track of the bolt staying open after last round but with obviously more bullets in the mag. And also had a few failures where the slide went forward but no bullet got chambered just got a click and a . I should also add the only mod to the pf9 is steel guide rod. I will switch it out and get back to the range but that’s not going to be for a week or so.

Was honestly not a bad experience in my eyes. I think it’s good to get in a routine when a failure happens and it’s easier to train when it’s actually happening instead practicing that you’ve had a failure.

If anyone has any experience, I’d appreciate the input.

Here is a few targets. Handguns were 15 feet. Ar was at 75. I circled some one shots hits with the ar. Yes I was actually aiming at those spots.