Skip to main content

edcforums

Vaping question

  • This topic is empty.
Viewing 1 post (of 1 total)
  • Author
    Posts
  • #81368
    admin
    Keymaster

    A question for you fellow vapers.

    I kicked the habit a year and a half ago (yay!) and I want a new setup, and I need some advise.

    My current setup is a Kanger Evod clearomiser (single bottom coil, 1.8 ohms) on a variable voltage battery vaping at 4.2 volts (or so the dial claims).

    This works good and well and is much better than those disposable clearomisers. Now the thing is that I want more clouds and more taste. Preferable more throat hit too.

    I’ve been given a Dovpo mini 50 watt mod, and I intend to use that, but I need a clearomiser to work with it, and I’m lost.

    Specs for the Dovpo as per their website:

    Size: 83mm X39mm X24mm
    Material : Aluminium
    Operating Wattage: 7W-50W
    Resistance Range: 0.2ohm- 4.9ohm
    Maximum Output Current:17 Amperages
    Battery Working Voltage: 3.2V-4.2V
    Variable Wattage:Wattage can be adjusted from 7.0W to 50W in 0.1 watts increments
    *ON/ OFF Battery Switch
    *OLED Display
    *Short Circuit Protection
    *Low Voltage Protection
    *Overheat Protection
    *Battery Reversal Protection
    *Overtime Vaping Warning
    *Overcurrent Protection
    *Power-off memory function
    *Using 18650 External battery

    I’ve got two 30A 2100mAh 18650’s to go with it.

    A couple of things to take into consideration: the legal limit for clearomiser capacity is 2 ml here (don’t ask me why) and I’m not looking for the ultimate smoke machine, just a step up from what I have now.

    So here’s for the questions:

    Can I use any clearomiser I like or do I need a special thing for this specific mod? I’ve read things that if you want to vape at 50 watts that you’d need something more substantial than the Kanger Evod I’m using now. But if that works I’ll be fine with that.

    I’ve been reading about sub ohms, high ohms, low and high watts and voltages (watts=voltage²/ohms right? Meaning that if you raise the ohms, you’ll have to raise the voltage to get the same vapour and vice versa.

    So in short: what type of clearomiser do I need for the Dovpo, and can I still use my Kanger Evod (still have a couple of coils laying around, would be a waste not to use them)?

    Thanks in advance!

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.